How To Use Nail-free Glue?

Instructions for use:

Dry bonding method (suitable for lighter materials and lightly loaded joints)

1. Extrude several lines of "zigzag nail-free glue" at a distance of 40 cm

2. Press the side with nail-free glue to the bond, gently pull it apart, and let the glue evaporate for 2-5 minutes

3. Then press the two sides together

Wet bonding method (suitable for places with large forces, used with clamping tools)

1. Apply nail-free glue according to the dry bonding method

2. With clamps, nails, or screws, immediately glue both sides or nail them

3. After the glue has solidified (24 hours), remove the clamp

The bonding method of load-bearing materials

First bond the load-bearing materials together, then separate them, wait for about 5 minutes to dry, and then firmly press and tap the materials to be bonded again to make them in place. Support with braces if necessary (load-bearing materials must be supported)

usage restrictions

Not intended for use on materials that have been immersed in water for extended periods of time, nor is it suitable for use on polystyrene or polystyrene foam

Clear method

When the nail-free glue has not solidified, it can be removed with a damp cloth or solvent oil; after drying, it can be removed by scraping or sanding

Precautions:

This product is flammable. The place where it is used should be well-ventilated to prevent its volatile gas from being inhaled into the body, and it should be placed out of the reach of children. Please use alcohol or banana water when diluting and cleaning, and please pay attention to the rules of solvent use. If there is any residue in the cylinder after construction, the outlet should be plugged with a hard object to prevent it from drying out. Avoid fireworks, heavy falls, sun exposure, and excessive accumulation when storing