When The Wall Is Renovated For The Second Time, How To Quickly Tear Off The Wall Covering Without Hurting The Wall?

It's New Year's, and I want to renovate the wall with a new look. How to tear off the old wall covering efficiently?

Hard tearing can easily tear the putty layer on the wall, and it needs to be repaired later; the wall covering has been treated with a layer of waterproofing, and it is difficult for water to penetrate into the bottom layer by tearing with water; the speed of using an iron is too slow, and the time cost is high. With the hot ironing machine, not only the tearing speed is fast, but also the wall is not damaged. Let's take a look below! Both cold glue wall coverings and hot glue wall coverings are applicable!

Tear off the wall covering correctly in three steps

Step 1: Remove the door suction, switch panel, etc. to facilitate the tearing of the wall covering.

Step 2: If the old wall covering is pressed on the door cover and skirting line, it is necessary to cut all the wall covering first.

Step 3: Iron the wall covering with a hot iron. The steam can quickly penetrate into the bottom layer of the wall covering, and the hot air can quickly dissolve the glue so that the viscosity of the glue can be quickly reduced, and the wall covering can be quickly separated from the wall without pulling the wall covering hard, and the damage to the wall can be minimized.

Does the wall need to be treated after the wall covering is torn off?

If the wall covering is torn off, the wall is flat, the wall is not damaged, the firmness of the wall is very good, and the wall base film has been used to treat the wall when the wall covering is first applied. good. If the wall is not flat after the wall covering is torn off, and the wall is falling off, it is necessary to reprocess the base layer and repaint the wall base film.